The barrel of this gelatinizing machine is made of SUS304 stainless steel, and both the stainless steel stirring impeller and the shaft are. Heating can be done with water or heat transfer oil. The temperature controller can set the temperature range of the PVA solution in the bucket to 10 to 85 degrees, and the oil temperature to 110 degrees. Two temperature controllers can control the temperature simultaneously, and no foaming occurs during stirring. The glue dispenser adopts a jacketed heating method and is insulated with an aluminosilicate fiber layer on the outside. The stirring shaft of the 3-50L equipment can be easily disassembled, and the frame components can rotate 90 degrees, facilitating the removal of the bucket and the taking out of the melted adhesive. The melted adhesive does not bubble or burn.
A defoamer is an industrial device used to eliminate bubbles inside or on the surface of materials. Through principles such as vacuum, pressure or centrifugal force, it causes the bubbles to rapidly expand, burst or be discharged, thereby enhancing the uniformity, strength and appearance quality of the product.
Main application：
1. Electronics industry: Remove bubbles from display screens, chip packaging, and circuit board adhesives.
2. Optical materials: Eliminate bubbles in the lens, film material, and optical adhesive bonding layer.
3. New energy: Used for coating lithium battery electrodes and defoaming of fuel cell membrane electrodes.
4. Medical and Scientific research: Handling biological agents, reagents, and medical packaging materials.
5. Composite materials: Enhance the compactness of resins, adhesives and coating materials.
Technical specification
| Model | Volume(L) | ΦD(mm) | H(mm) | Motor power(KW) | Heating power(KW) |
|---|---|---|---|---|---|
| ATL-I-30 | 30 | Φ340 | 350 | 0.37 | 2 |
| ATL-I-60 | 60 | Φ420 | 420 | 0.75 | 3 |
| ATL-I-100 | 100 | Φ500 | 520 | 1.1 | 5.5 |
| ATL-I-200 | 200 | Φ630 | 650 | 1.5 | 7.5 |
| ATL-I-300 | 300 | Φ720 | 750 | 2.2 | 7.5 |
